Voltage: DC12V, DC24V, AC220V, please indicate the voltage in the remarks when you take the photo, the default voltage is DC12V, and AC220V requires a power adapter plus 10 yuan With power adapter AC220V/DC12V(1A)
1. Product introduction: The learning wireless remote control switch is a widely used wireless control device. It adopts microprocessor intelligent control. It can be used in garage door control, lighting control, remote control curtains and other fields. It is easy to install and simple to use. Reliability and other advantages. 2. Overview: 12-way remote control receiving board, connected to DC 12V power supply through the terminal, is suitable for electrical control circuits such as anti-theft alarm, remote control electric doors and windows, signal control, industrial control, lifting equipment, etc. The relays of the receiving board can withstand a maximum operating current of 10A/220VAC and can directly drive AC loads. Each relay has a set of normally open to normally closed contacts and corresponding terminals.
Third, the technical indicators of the remote control 1, working voltage: DC12V(One 23A battery) 2, working current:≤150mA 3, working frequency: 315MHz 4. Launch distance: 500 meters or more(Open land) four,Receiving board technical indicators Working voltage: DC12V Working frequency: 315MHZ Contact capacity: 10A/220VAC) Quiescent current: less than 20mA Receiving sensitivity:>-105dB Output status: 12-way relay normally open(Normally closed)contact Module size: 14.5×9×4 cm outside shell: yes Working mode setting
Mode 1, self-locking mode learning remote control 1 button Mode 2, non-lock mode learning remote control 2 keys Mode 3, interlock mode, learning remote control 3 keys Mode 4, 6-way self-locking, 6-way non-locking mode learning remote control 4 keys Mode 5, 1 way self-locking 11 way non-locking mode learning remote control 5 keys Mode 6, 2-way interlocking, 5-way non-locking, 5-way self-locking mode, learning remote control 6 keys
Change the working mode, first reset it and then press the mode button again to learn the remote control study method:Turn on the power supply, press the learning button on the receiving board, release the learning button until the two status indicators are off, then press and hold the remote control button of the corresponding mode, wait until the red light flashes 2 times and then release the remote control button. Indicates successful learning (factory settings have been learned, follow the instructions to connect the line and you can remote control, no need to re-learn). Clear code method:Press and hold the learning button until the red light flashes, indicating that the code has been cleared successfully (1)Interlock type(L)For example, 12-way interlock, press 1 to connect the first way, press 2 to turn on the second way and disconnect the first way...12-way interlock can only connect to one way. (2) Inching type(M)For example, the relays corresponding to the 12-way jog and 12-way press the remote control button are respectively connected, and the relay is disconnected when the hand is released. (You cannot press multiple buttons at the same time). (3)Self-locking type(T)For example, the 12-way self-locking, the 12 buttons of the remote control respectively control the 12-way independent work, press the remote control button once to lock the corresponding relay, and press it again to disconnect.
8. Wiring method Nine, shape and fixing method (fixed with screws and guide rails) |