Badminton racket, wire tube, nail, luxury maintenance, care kit
1. Hot-pressure flared mouthpiece: hot horn mouth: press and hold the switch for 2 or 5 seconds, and grasp it according to the melting point of the wire tube. After preheating, do not continue to press the switch, place the frame on a flat table, and press the wire tube vertically until it is formed.
Note: The Li-Ning line tube is preheated for about 2 seconds, and the ordinary line tube is about 4-5 seconds. Press 5 times to turn on, and then 5 times to turn off.
2. Double/single wire tube nail remover(Random color of pen body): After tightening the screw clockwise, pull out the nail without hurting the paint.
3. Nail turning device: insert it into the wire protection tube and turn it clockwise by 90 degrees. In order to avoid pulling the wire at the same position multiple times, increasing the life of the wire protection tube,
4. Reaming rod: When the wire tube cannot pass through the hole, it is enough to grind the hole 1-2 times.
5. Guide nail cone: used when nailing into one side and unable to pass out from the other side.
6. Diagonal pliers: Cut off the tail of the over-long and over-long wire protection tube.
Note: Because the melting points of various line pipes are different, you need to test it yourself at the beginning.
Thread protector Mix and match about 700, about 10 shots. Thread protector is not included in the kit and needs to be purchased separately.