newextension:tg1472525712 |
|
|
newextensionend:tg1472525712 |
Special reminder: This is a continuous order for the special model of the Kasen Strong Bow series. Other models of rackets must be useless, so there is no doubt! ! !
Important note: After the strong bow on the original racket is installed, the double-line hole is burned with a machine to burn the bell mouth, which is more beautiful and natural, so some pro will say how it will be different after it is installed, and it is not as strong as the original racket. The bow strips are beautiful. This is a problem of craftsmanship. It is not a matter of strong bow strips. Unless you buy tools for ironing the thread protection tube yourself, and iron it yourself after installation. Some people say why not iron it before sending it. Haha, if it is ironed first Then how do you fit him into the racket hole?
The strong bow has 22 holes in total, 7 large holes on each end(2.6 Double wire hole), 8 small holes in the middle(2.1 Single wire hole), Need to be used on other rackets or other positions on the racketRelatives and friends can refer to their own racket hole position and strong bow hole position, corresponding to the cutInto the hole.
It is suitable for badminton rackets such as 300A/300D/300TI/C7/F9, and other rackets can also be used, because there are differences in the size of the holes and the pitch or arc, it may need to be cut before use.
The role of the strong bow:
1. It can heavier the head and make the racket more offensive.
2. It can increase the elasticity of the thread.
3. It can prevent the racket from bursting with high pounds,Avoid collapse.
4. It can protect the line, especially for golfers who are used to checking the ball with a racket, and avoid friction between the line and the floor.
Strong bowUnlike single-grain orders, it’s definitely more difficult to install by hand. When installing, start from one end and encounter the wire tube stuck in the racquet string hole. Use an awl to help it, pull it a few times, and find a way to put it in. Strong bowAlign the string tube with the racket string hole, then press it with your hand to enter it, and then install it step by step and it will be OK.
Special note: As shown in the figure below, there is a small bubble on the strong bow which is the clamping point of the mold. It is a normal phenomenon. There will be long lines like this, and it will not affect the use. If you have made a mold, you should know how Going on.