It is extremely difficult. Before placing an order, please think about your practical ability, observation ability, patience and completeness of tools. We can only provide pictures, and are not responsible for responding to any operational problems.
Previously, we have shared a number of 76-hole lines of anti-collapse and nail solutions, including:
1. Normal racket surface-normal line hole(represented by duora10);
2. Normal racket surface-adjustment line hole(JS12 as representative);
3. Small racket surface-normal line hole(represented by arcz);
4. Small racket surface-adjustment line hole(JS10 as representative).
This time we will continue to share, a racket with a normal surface-80-line hole(MX80 as representative)The anti-collapse even nailing program.
Under normal circumstances, the genuine Victor Victor MX80 will collapse in different degrees after using it many times.
=============
You who look healthy are scarred in your heart...
Start with the care plan of the head.
1. Ordinary rubber particles, which need to be rotated and replaced frequently, which is more troublesome;
2. MP10 continuous nails, because MX80 already has the sweet spot MP technology, and then superimposing the MP line with continuous nails will make the continuous nails and the line groove float too high, which will affect the safety of the ball line and increase the wind resistance;
3, DZ8 with nails, dzs racket head with 8 nails in a single-track modified version, the whole is relatively flat, suitable for the MP groove of this racket head.
===================
There are some scars that only show up after the dead of night;
Some line marks can only be seen after removing the string.
===================
Think of me as being exaggerated. Exaggerating is because I am afraid(Collapse)...
When there is no DZ8 continuous nailing program, MP10 continuous nailing is the only racket head continuous nailing program. After the sweet spot wave + continuous nail wave, the arc is double superimposed, it looks a bit like a teletubbies.
========================
So in the end, we chose the flat groove type DZ8 continuous nail + L-shaped widened nail.
=========================
The shoulder position is compared with the second brother-in-law''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''s split line and nailed to compare the hole positions. Multiple line holes are consistent. Compared with the major operations of duora10 that cut three or four times at every turn, the MX80 only needs to use two knives to nail the middle part Just cut it off, which is much lower in difficulty.
=========================
Count the big holes, cut a knife between the 4th and 5th holes,
As shown in the figure again, remove all the glue sections of the 5th and 6th holes.
=========================
It is not a problem for the rubber particles to get in, but it is not certain whether they can get out. It is better to prepare an awl as a guide hole for continuous nails.
=========================
Details of the overall plan of even nailing rubber particles
=========================
Threading to check the quality of the nail installation
=========================
The comparison between DZ8 with nails and without nails, and MP10 with nails, is protected, but not too overwhelming.
=========================
=========
--_--
--_--
--_--
--_--