Professional version to replace the badminton racket line protection tool
![](https://img.alicdn.com/imgextra/i2/318405391/O1CN018tk2411ph7pDvYaSM_!!318405391.jpg)
Amateur versionReplace badminton racket wire guard tool
![](https://img.alicdn.com/imgextra/i1/318405391/O1CN01xc2fbw1ph7pCtg3NA_!!318405391.jpg)
The professional version of the embossing pliers needs to be pressed twice, and the flaring is more perfect. The amateur version is used by amateurs, and it is enough to press once. Of course, the flaring is not particularly perfect.
Professional Flare Tool-Embossing Pliers
![](https://img.alicdn.com/imgextra/i1/318405391/O1CN01UzVafD1ph7lqVXssc_!!318405391.jpg)
Amateur Flare Tool-Embossing Pliers
![](https://img.alicdn.com/imgextra/i1/318405391/O1CN01QrYCFT1ph7lpe1Dtf_!!318405391.jpg)
Remove the badminton racket wire protection tube tool-take the nail cone
![](https://img.alicdn.com/imgextra/i3/318405391/O1CN01aReydc1ph7ln6UxoK_!!318405391.jpg)
Install badminton racket wire guard-guide hole cone
This awl pursues its pilot hole function. After all, it is a low-priced product and its appearance is flawless. Mind shooting carefully! ! !
![](https://img.alicdn.com/imgextra/i1/318405391/O1CN01IV3TO31ph7lpLAKuQ_!!318405391.jpg)
Trimming badminton racket wire protection tube tool-oblique cutter
![](https://img.alicdn.com/imgextra/i3/318405391/O1CN01z0RKBI1ph7pGiMiFi_!!318405391.jpg)
Rotating badminton racket wire protection tube tool-rotating cone
![](https://img.alicdn.com/imgextra/i2/318405391/O1CN01XjaIMe1ph7lhUKqAo_!!318405391.jpg)
The extension nail is blunt and oblique cut, not sharp, not sharp, not sharp, with a little paint stain!
![](https://img.alicdn.com/imgextra/i2/318405391/O1CN01viV7lt1ph7q9pI8Nw_!!318405391.jpg)
Toolkit
![](https://img.alicdn.com/imgextra/i4/318405391/O1CN01p4yWjT1ph7o6gQ0HA_!!318405391.jpg)
![](https://img.alicdn.com/imgextra/i2/318405391/O1CN018DB5Bq1ph7o8JLPBq_!!318405391.jpg)
![](https://img.alicdn.com/imgextra/i3/318405391/O1CN01WKbKd81ph7pHQAATZ_!!318405391.jpg)
Question: Why is the head of the embossing pliers a bit misaligned?
Answer: Each one will have a slight deviation, because the thread hole itself is a hole of about 1-2mm, not a point, and when using this, you do not press directly, but rotate it after biting it. Must be accurate in the strict sense.