The listed price is the price of one.
contain:【Lights, electronics, cable ties, hot melt adhesive】(The vibrating light flashes red and blue and changes color, and the picture is the color of the snapshot)Free shipping for orders of 10 or more! 10% off for purchases of 20 or more!(Automatically change the price after selecting the quantity)
Get 2 flashing lights for every 20, get 2 for every 20, and so on! Principle of vibration light:Each time it lights for about 15 seconds, and then stops. There is vibration and it is bright for 15 seconds, which can brighten eight to nine thousand times! Power saving and durable.Instructions:You have to stom on your foot lightly or run or the brakes will flicker. If you tremble when you’re on the street, it won’t be bright if you just walk around. Please pay attention to everyone~ Sensitivity of vibrating light: It is recommended to install it on the sole of the knife holder.
The higher the installation, the weaker the vibration feedback transmitted by the ground, and the greater the vibration will be before the light flashes! Installation tutorial:
Note that it must be installed horizontally to have an effect!
method one:
Shoe soles(It is more recommended, because it will not be crushed when you fall)
Key point: stick more glue to prevent it from falling!
Important reminder: Our glue is non-marking glue, it can be removed by blowing hot air with a hair dryer when removing. After removal, the glue on the shoes can be cleaned up only by blowing and heating! Please rest assured! Method Two:
Tied with a cable tie(This method may grind the lamp when you fall! Please choose a location that does not grind)