Instructions for use | 1. Insert the cigarette lighter plug into the cigarette lighter socket in the car. 2. There is a power switch control button on the top of the handle. Push the control button to the ON position to use it, and push it to the OFF position to stop using it. 3. Replace the suction nozzle depending on the use occasion. The 2.5-meter-long cigarette lighter connection line is enough to cover any position inside the vehicle to vacuum. 4. When in use, the suction port is flat against the ground to achieve better results. 5. There is a front shell device button in front of the power control button. Press down to remove the front shell. When you have finished using or need to clean, disassemble the front shell cleaning filter to extend the life. The cleaning filter must be kept away from eyes and ears. 6. This product can not be used to inhale burning materials, such as burning cigarette butts. 7. If it is a wet and dry vacuum cleaner, pay attention to the height (capacity) of the water blocking pipe of the front cover when absorbing water and damp objects. The height of the suction volume should not exceed the water blocking pipe. (It must be turned off, open the front cover, pour out the water or wet liquid and reinstall it before it can be used again). |
cleaning method | 1. Remove the foreign matter from the mesh bag, press the spring and turn the mesh bag to remove it, insert your hand into the mesh bag to take out the filter bag, and pour out the foreign matter in the filter bag. 2. Cleaning the filter bag: a. Wipe the filter bag b. Shake the filter bag in the garbage bag c. Wash with detergent, wipe with paper towel after washing, and confirm whether it is kept clean before using it again. 3. Reinstall the filter bag: Align the lower end of the filter bag with the mesh bag and install it together so that the spring and the filter bag are connected together. Cleaning of plastic parts: Use wet wipes with hot water and mild detergent, and avoid other detergents that may contain chemicals to avoid damaging the plastic part. |