SF Land Shipping(Note: Inner Mongolia/Xinjiang/Tibet/Heilongjiang/Jilin/Gansu/Ningxia/Qinghai/Inner Mongolia and other regions need to add 15 yuan for SF land transportation. Fayunda/Yuantong Express Free Shipping)
★★★★★★This camera has been tested by the store’s real machine to ensure that it fits in place. By default, there is no waste discharge after receiving the sticker. The reason is that after the waste is discharged in advance, depending on the region, it is easy to get off the road when the wind blows and the sun , So it has not been emptied. Please remove the useless waste paper after receiving it. Paste it in order from top to bottom. Start with the hood, align the holes when pasting, and then smooth it out forcefully. The lighter or hair dryer heats and fixes it, making it harder to edge. ★★★★★
The following is the display effect of the store sticking machine
It took 15 minutes and there were a few flaws and no post-image processing. The store believed that it was 98% of the skill, and hoped that subsequent buyers would continue to work hard to achieve the effect.
★Pre-post preparation:
1: Prepare tools: tweezers, hair dryer(If not, find a lighter), Paper cutting knife, alcohol bag, cleaning cloth.
2: Wash your hands, prepare a clean desk or workbench, sit in a quiet and bright environment, and relax.
★Work in post:
1: After receiving it, first remove the excess stickers according to the hollow in the drawing, and cut out all the internal round holes and special-shaped waste paper.
2: Wipe the camera clean with an alcohol bag in the paste, and then study the corresponding position of each hole after it is dry.
3: The correct order for most of the paste is: paste the part with many holes first, then paste the small area, start from the top, then paste the front and back holes, then paste the bottom and skin. Use a hair dryer to smooth the warped edges after applying one or two stickers.
★Notes:
1: It is difficult to paste the parts with many holes. Be sure to align carefully. If the paste is not correct, it can be peeled off for multiple tests. The carbon fiber is flexible. If it is shorter than 1 mm, it can be fired.(hair dryer)Heat for one or two seconds to stretch. If it is about 1 mm too large, just heat it once, and the extra part of the belly will automatically disappear.
2: Be sure to align the holes first and then smooth and press by hand. If you encounter a large porous sticker, you can try to cut in half from the fine part to reduce the difficulty of filming; if there are holes on both ends, the two ends are separate Align the holes and then smooth it to the middle. If there is a raised part that does not fit, use a cutting method to eliminate the raised part and flatten it left and right.
3: Press and smooth every few small pieces, and then heat to fix the corners. After all the work is finished, you can press it with a hair dryer to make sure that each piece fits the camera completely. This is a work process that tests patience. You must be patient, work quietly, and don’t be impatient. It can be slow but not easy. I wish the pasting machine success and protect the camera.(Lens)Anti-wear, beauty camera overall effect.