National free shippingEvent Date: 2021-01-02 11:46:00-2021-02-01 11:46:00 | Single order full28yuan,Shipping area: Shanghai, Jiangsu, Anhui, Zhejiang, Shaanxi, Gansu | Single order full38yuan,No mailing area: Xinjiang, Tibet, Jiangxi, Ningxia, Qinghai, Hong Kong, Macau, Taiwan, overseas |
|
Specification of carbon fiber film for air guide groove:
One piece is 50cm*50cm two pieces are 50*100cm and so on ······Width 50cm(constant)
Q: What is the air guide groove?
Answer: The air guide groove is the reverse side of the sticker with very small lines, it is not easy to produce bubbles during construction.
Look at the adhesive part. Ordinary adhesive is relatively smooth. Pasting requires certain skills.
The adhesive part with air guide groove has grooves
Adhesive technology with air guide groove requires low, good stretching ability
It is recommended that novices choose the one with air guide groove
Dry paste method
1. Clean the place where the object is pasted. If possible, use a non-fiber cloth dipped in 50% alcohol or isopropanol or acetone to scrub, or use detergent water; the surface that has been cleaned by the solvent needs to be completely volatilized after the solvent Paste available
2. Under normal circumstances, slowly stick it on one side, smooth it down with a tool or finger, and peel off the bottom paper.
3. If the length and width of the sticker are less than 10 cm, you can tear off the sticker and paste it again. But you must be careful not to accidentally stick or fall off the ground and stick to dust.
4. Use a clean rag or scraper, fingers, etc. [such as phone cards or credit cards] to wipe or scratch repeatedly on the film; until there are no bubbles in the film,SuggestDo not rub the film within 24 hours after applying it.
Wet sticking method
【Wet sticking method steps】Tools used: watering can, clean rag, scraper, utility knife, hair dryer or heat gun
1:Clean the surface to be pasted. Before preparing to paste the paper, spray the diluted detergent or glass water evenly on the surface to be pasted (after cleaning the pasted part, spray water on the part to be pasted)—&mdash ; Mainly used to reduce the viscosity of the sticker and facilitate the adjustment of the position.
2:After determining the position to be pasted, lift up the sticker and paste it from right to left [or from top to bottom] and press it on the object with a rag, then press it on the object with a rag, and then uncover the bottom paper while pressing it with the rag.
3:After pasting, check whether the corner is leaking or wrinkle. If it is inappropriate, adjust it in time. After confirming the general position of the figure, use a scraper to repeatedly scrape off water and air bubbles. When using the scraper, scrape diagonally from right to left.
4:Divide the edges evenly with a utility knife, and paste them inward.
5:Try to let the moisture in the object dry as much as possible. If possible, use a heat gun or hair dryer to moderately heat and dry it. Suggestion: Try not to expose to the sun within 24 hours, and not rubbing within 48 hours
6:Revolutionary subversive carbon fiber sticker product, three-dimensional pattern, can be distinguished by touching it
7:The tensile force is super strong, no matter how big the arc is, it is not afraid(A large amount of heat gun or hair dryer is required)
8:The glue is first-class, super durable, and will not damage the original paint at all
9:Carbon fiber with air guide groove, no longer have to worry about bubbles due to temperature changes