Disassembly:
1. Pull out the base of the dust cover(There is no need to pull out the bright frame when pulling out the base of the dust cover. Here is a demonstration), The method is as shown in the figure below, use a fruit knife to pry the yellow dots, pull it up, and start from the back corner first.
2. Use needle-nose pliers to pry loose the metal ring under the gear head, then the gear head can be pulled out.
3. Use a screwdriver to pry the plastic ring at the bottom of the gear head and separate the old dust cover of the original car.
4. Remove the staples from the base again. If it is troublesome, just tear off the dust cover without removing the staples, which will not affect the installation.
5. Put the new holster back on the gear head and forcefully snap back the plastic ring to clamp the holster.
6. Wrap a circle of double-sided tape on the bottom edge of the new leather case(Just ordinary double-sided tape will do), Glue the leather case back to the base.
7. Glue it as shown in the figure below. After the double-sided adhesive is glued, there is no need to use staples to order it, and it will not fall off, because that part will not be subjected to external force, and it will be clamped after it is snapped back to the bright frame, so don''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''t worry Will take off.
8. When the gear head is fixed to the gear lever, the bottom of the gear head is tightened with a clamp.(The clamp is included with the dust cover).
The base of the dust cover snaps back to the bright frame, and you''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''re done.
The shift head structure of some models is different. The main difference is that the plastic ring at the bottom of the shift head clamps the dust cover and the method is the same.