This scheme is universalnvidia graphics cardPublic or non-public(Non-public version)Graphics card
RTX2060/2060super
It is recommended to pay attention to the requirements of the water-cooling head when choosing the integrated water-cooling or split-water cooling head.
There are two types of screws for this fastener, please measure the thickness of the water block and select the appropriate screw length
method:
Use a ruler to measure the thickness of the water block you want to use plus 15-17 mm is the length of the screw you want to choose
Fixed buckle/component 30mm screw version Recommended split water block such as split copper water block
Fixing fastener/component 55mm screw version. Thicker split water block is recommended, such as split copper water block or integrated water block.
Fixing fastener/component 65mm screw version is recommended for thicker integrated water block
It can be used with most water-cooling heads on the market, but it’s better to look better if it fits.
note:Turing architecture graphics cardThere are two sets of 4-hole fixing on the main board. This clip can only be used to fix the inner 4 holes and the outer 4 holes cannot be used, so please choose the water block suitable for the inner 4 holes.
The video memory can be without a heat sink. If there is no fan under the chassis, it is recommended to install a graphics card companion to cool the power supply and video memory.
After the modification is completed:
Can reduce temperature, reduce noise, improve performance, improve stability
Reduce graphics card damage caused by high temperature and extend graphics card life
The current store is poor. The measured map. Buy this buckle. The successful modification will return the picture. Reward2 yuan
This buckle is a universal buckle
Laser cutting stainless steel plate
Supported mainstream graphics card installation hole distance:
AMD graphics card(A card)43*43-64*64
nvidia graphics card(N card)64*43 can be installed
Special:
The spring is made of stainless steel, customized double flat head 7 turns, wire diameter 0.7 mm, full elasticity, rebound without deformation-new upgrade
The screw material is made of stainless steel. Customized half-thread screw. Energy efficiency reduces the wear and tear on the motherboard. No rust. Long time makes it more reliable.
The nut is made of copper, galvanized, and hand-tightened to reduce the overall weight
The gasket is made of harmless nylon white, semi-permeable, beautiful and durable, reducing single-point pressure and wear on the motherboard
installation method:
After removing the card, apply thermal grease
First remove the non-slip nut, fixing nut and one piece of gasket
Put the graphics card upright and insert 4 screws with washers, springs and washers from the back of the graphics card
After laying flat
Find a good angle for the water blockCentered and flattened Press and hold the laser-cut stainless steel fastener with one hand, and screw on the big nut(Fixing nut)After adjusting the play, tighten the last small nut (Non-slip nut)
Note: When screwing the screw, try to tighten it by hand, not to tighten it, to prevent excessive core pressure from causing damage
Method of measuring hole distance:
1. Measuring inner hole distance
2. Measure the outer hole distance