ASUS A550 X550 FX50J X4720 and other same models
\ \
Applies to:
\ \
ASUS A550 X550 FX50J X4720 and other models with the same internal structure
\ \
Package includes:
\ \
Package 1: 2 customized bending copper pipes + thermal conductive glue + Shin-Etsu 7921(High-end silicone grease)+4 heat sinks
\ \
Package 2: 2 customized curved copper pipes + thermal conductive glue + Shin-Etsu 7921(High-end silicone grease)
\ \
advantage:
\ \
Improve the temperature of CPU, graphics card and South Bridge motherboard, the effect is remarkable.
\ \
It will not block the position of the screw, so it is convenient to disassemble the machine in the future, replace the thermal grease and clean the dust.
\ \
note:
\ \
This package is a material package for reforming the heat dissipation. It does not include the radiator and fan of the original machine. If you are still unclear, please contact the seller.
\ \
a:
\ \
\ \
\ \
Operation tutorial:
\ \
first step:
\ \
To disassemble the machine, first take out the entire motherboard, then remove the screws of the CPU and graphics card, take off the entire radiator, remove the fan, and clean up the dust at the air outlet, as well as the CPU and graphics card, as well as the radiator. The silicone grease residue.
\ \
\ \
The second step:
\ \
CPU and graphics card, as well as the two positions on the radiator, a total of four positions, apply the thermal grease of the syringe, the chip of the CPU and graphics card, can be a little thicker, the two positions on the radiator must be thin and translucent It''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''s okay. After smearing, it is best to take a picture and take a look, confirm that there is no problem before installing, install it, and tighten the screws.
\ \
\ \
third step:
\ \
Start to paste and fix the copper tube and the heat sink. The position of this picture, paste and fix, squeeze a little or a piece of thermal conductive glue on the position where the copper tube and the radiator are in contact with the top and bottom of the paste.
\ \
\ \
\ \
the fourth step:
\ \
After the copper tube is pasted, use a heavy object to press on the spot where the thermal conductive glue is attached to fix the copper tube, and then wait for 90 minutes to dry, at least one hour is fine. The heat sink is pasted and fixed, and no weight is required. Then the time is up and it''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''s done.
\ \