\ \
\
\
\
\
\
\Happy shopping!\
\
\ \
\
Huawei series network equipment:
\
\
\
\
\
\
\
H3C series network equipment:
\
\
Cisco series network equipment:
\
\
\
\
\ \
\
\
\ \
\ \
AP4030TN access point
\ \
AP4030TN is a wireless access point released by Huawei that supports the 802.11ac standard. It adopts a three-radio design and supports SDR(Software defined radio frequency)Technology, each radio frequency supports 2×2MIMO and two spatial streams, suitable for deployment in general education electronic classrooms, high-density, supermarkets and other scenarios
\ \
Key features
\ \
\ \
\
\
\
\
\- \Adopt three radio frequency design, including 1 5G radio and 2 2.4G/5G radios(Support 2.4G and 5G switching), Support SDR(Software defined radio frequency)Technology, radio frequency function customization, to meet different application requirements;\
\- \ Support link aggregation of dual Ethernet interfaces to ensure link reliability while increasing business load balancing capabilities;\
\- \ Provide USB interface, can be used for external power supply, can also be used for storage. \
\- \ \
\- \
Product Features
\WLAN features
\\- \ Compatible with IEEE 802.11a/b/g/n/ac standard\
\- \ Supports maximum consolidation ratio(MRC)\
\- \ Support space-time block codes(STBC)\
\- \ Support low density parity check(LDPC)\
\- \ Support maximum likelihood decoding(MLD)\
\- \ Support frame aggregation: A-MPDU(Tx/Rx), A-MSDU(Rx only)\
\- \ Support 802.11 dynamic frequency selection (DFS)\
\- \ Supports ShortGI in 20M, 40M and 80M modes\
\- \ Based on WMM(Wi-Fi Multimedia)That is, the mapping and priority scheduling rules of Wi-Fi multimedia standards to realize priority-based data processing and forwarding\
\- \ Support automatic and manual rate adjustment methods\
\- \ Support WLAN channel management and channel rate adjustment\
\- \ (Note: For specific management channels, please refer to "Country Code & Channel Compliance Table".)\
\- \ Support channel automatic scanning function, automatically avoid interference\
\- \ Support each SSID in the AP can be independently configured to hide the function\
\- \ Support SST(signal sustain technology)\
\- \ Support U-APSD power saving mode\
\- \ Support CAPWAP in FIT AP working mode(control and provisioning of wireless access points)That is, wireless access point control protocol tunnel data forwarding\
\- \ Support AP automatic online function in FIT AP working mode\
\- \ Support extended service set ESS in FIT AP working mode\
\- \ Support WDS in FIT AP working mode\
\- \ Support Mesh\ in FIT AP working mode
\- \ Support multi-user CAC\
\- \ Support Hotspot2.0\
\- \ Support 802.11k, 802.11v protocol intelligent roaming\
\- \ Support fast roaming(≤50ms)\
\
\Network characteristics
\\- \ Comply with IEEE 802.3u standard\
\- \ Support auto-negotiation of speed and duplex mode, automatic MDI/MDI-X\
\- \ Compatible with IEEE 802.1q\
\- \ Support to divide VLAN according to the SSID that the user accesses\
\- \ Uplink Ethernet port supports VLAN trunk function\
\- \ Support AP uplink port management channel networking in two modes of tag and untag\
\- \ Support DHCP Client, obtain IP address through DHCP\
\- \ Support two ways of tunnel forwarding and direct forwarding of business data\
\- \ Support access isolation between different wireless terminals in the same VLAN\
\- \ Support user access control(ACL)\
\- \ Support LLDP link discovery\
\- \ Supports CAPWAP interrupt service retention in direct forwarding mode in FIT AP working mode\
\- \ Support AC unified authentication in FIT AP working mode\
\- \ Support AC dual-link backup in FIT AP working mode\
\- \ Support NAT in FAT AP working mode\
\- \ Support IPv6 in FIT AP working mode\
\- \ Support Soft GRE\
\- \ Support IPv6 SAVI\
\- \ Support IPv4/IPv6 ACL\
\
\QoS characteristics
\\- \ Based on WMM(Wi-Fi Multimedia)That is, the mapping and priority scheduling rules of Wi-Fi multimedia standards to realize priority-based data processing and forwarding\
\- \ Support WMM parameter management by radio frequency\
\- \ Support WMM power saving mode\
\- \ Support upstream message priority mapping and downstream traffic mapping\
\- \ Support queue mapping and scheduling\
\- \ Support bandwidth restriction based on each user\
\- \ Support adaptive bandwidth management, dynamically adjust user bandwidth allocation automatically according to the number of users, environment and other factors to improve user experience\
\- \ Support Airtime scheduling\
\- \ Support the Lync API of Microsoft Corporation. In the voice environment, use Lync API to identify and schedule to ensure the voice call effect\
\
\Safety features
\\- \ Support Open-System authentication method\
\- \ Support WEP authentication/encryption method, encryption word length supports 64-bit, 128-bit and 152-bit\
\- \ Support WPA/WPA2–PSK authentication/encryption method(WPA/WPA2 Personal Edition)\
\- \ Support WPA/WPA2–802.1X authentication/encryption method(WPA/WPA2 Enterprise Edition)\
\- \ Support WPA-WPA2 hybrid authentication\
\- \ Support WAPI authentication/encryption method\
\- \ Support WIDS and WIPS, including illegal device detection and countermeasures, attack detection and dynamic blacklist, STA/AP blacklist and whitelist functions\
\- \ Support 802.1x authentication, MAC address authentication, Portal authentication, etc.\
\- \ Support DHCP Snooping\
\- \ Support DAI(Dynamic ARP Inspection)\
\- \ Support IPSG(IP Source Guard)\
\- \ Support 802.11w protocol, encrypt management frame\
\
\Maintenance features
\\- \ Supports centralized management and maintenance of AP through AC in FIT AP working mode\
\- \ In FIT AP working mode, it supports AP automatic online function, and automatically loads the configuration, which can be plug and play\
\- \ Support WDS zero configuration deployment in FIT AP working mode\
\- \ Support Mesh zero configuration deployment in FIT AP working mode\
\- \ Support batch automatic upgrade in FIT AP working mode\
\- \ Support Telnet\
\- \ Support STelnet, use SSH v2 security protocol\
\- \ Support SFTP, use SSH v2 security protocol\
\- \ Support serial port local management\
\- \ In FAT AP working mode, it supports Web network management to manage APs, which can be logged in through HTTP or HTTPS\
\- \ Support network management real-time monitoring of user configuration information and fast fault location\
\- \ Support SNMP v1/v2/v3 in FAT AP working mode\
\- \ Support system status alarm\
\- \ Support NTP in FAT AP working mode\
\
\BYOD
\Note: BYOD is only supported in FIT AP working mode.
\\- \ Support identifying device type based on MAC OUI\
\- \ Support identification of device type based on HTTP User-Agent information\
\- \ Supports device type identification based on DHCP Option information\
\- \ Support Radius server according to the device type carried in Radius authentication/accounting packets to issue forwarding/security/QoS policies of packets\
\
\positioning service
\Note: Location services are only supported in FIT AP working mode.
\\- \ Support Tag positioning for AeroScout and Ekahau\
\- \ Support positioning of WiFi terminal\
\- \ Cooperate with esight network management to locate illegal devices\
\
\Spectrum analysis
\Note: Only the FIT AP working mode supports spectrum analysis.
\\- \ For BabyMonitor, Bluetooth devices, digital cordless phones(Only supports 2.4G), Wireless audio transmitter(2.4G and 5G), Gamepads and microwave ovens and other interference sources to identify\
\- \ Cooperate with eSight network management to display the frequency spectrum of the interference source\
\
\ \
\
\
\
\
\ \