Production Method:
After connecting the cable and power, you can definitely get images and sound on the TV or monitor, and the blue indicator light is always on. Now the 283S capture box is ready to record.
If the input source is 1080P, the 720P/1080P indicator will display 1080P by default, indicating that the recording file is a 1080P file. You can press“720/1080” Press the button to set the recording file to 720P, and then the 720P indicator will light up. If the video input source is lower than 1080P, the 720P indicator will light up,“720/1080” The switch button will have no effect. Indicates that the recording file can only be of 720P or lower quality, depending on the quality of the input video source. The above functions can also be controlled by the remote control.
The video source indicator (HDMI/YPbPr/CVBS) will light up according to the actual video source input (while light on means CVBS). If there is no video source input or there is a problem with the video source, all LED indicators will flash. If there are more than two video sources input at the same time, you can pass”SOURCE”Press the key or the remote control to select the required video source.
Recording is very simple, as long as you lightly press the record button (or through the remote control), and you see the recording indicator light up, it means that the recording has started.
You can grab the picture through the SNAPSHOT button on the remote control, but it will not move during recording.
Connect the microphone to the MIC input port, you can superimpose the audio and video of the microphone and record them together, and you can also increase or decrease the input audio level through the microphone volume adjustment knob.
If you press the record button and the indicator does not change, there may be the following reasons, please confirm:
1, the input video source is not connected well
2, U disk, mobile hard disk capacity is full
3. The format of U disk and mobile hard disk is not suitable, such as exFAT format. Nine Vision Capture Box supports FAT, FAT32 and NTFS formats.
4. The U disk and mobile hard disk are not inserted properly
5. U disk, mobile hard disk or SD card is not ready yet, it usually takes 4~8 seconds after inserting
If you want to stop recording, you just need to tap the recording button again, and you will see the LED indicator flashing a few times and then turning off. At this time, recording has stopped and you can unplug the storage device.
Note: When the LED indicator is flashing, please do not remove the U disk or SD card, otherwise you may lose part of the recorded files. If the U disk is full of recording, the 283S capture box will automatically stop recording, and the previous recording files will not be damaged or lost.
Connect the USB flash drive with the recording file to the computer, and you will see the video recording file: 1080P recording file, the file name is Encode_1080P_1, 720 or 480 recording file is Encode_1.
For every recording/stop operation, the 283S capture box will create a new recording file: Encode_1080P_1, Encode_1080P_2, Encode_1080P_3…
The maximum size of each file is about 1.95GB (a 1080p video file is about 15 minutes). When you record a video over 1.95GB, the Nine Vision Capture Box will automatically save it as a file and continue recording. Example: When you press the record button once and prepare to record about 50 minutes of 1080P video, you will get four files: Encode_1080P_1, Encode_1080P_1_1, Encode_1080P_1_2… The first three files are 1.95GB each, each about 15 minutes long, and the fourth file is about 5 minutes long.
Note: Sometimes you may find that there are omissions in the playback of the recorded file. It may be because you are using a storage device in NTFS format.
And you didn’t click when you finally unplugged it from the computer”Safe exit”. If you try to exit safely and still do not solve the problem, please try to format the storage device as FAT32 and try again.